DORSAL/LATERAL CYLINDER BASE EQUINE TABLE
The Dorsal/Lateral Cylinder Base Equine Table is equipped with 4-way tilt capability. The hydraulic system includes a total of eight hydraulic cylinders that work individually and in pairs, to provide this versatile 4-way tilt capability. This model can achieve Trendelenburg positioning via hydraulics. The table can be put in a stationary position by extending the four lower cylinders, and lifting the table base frame off the casters. The casters must be removed to achieve the lowest operating height.
Technical specifications
• Self contained power unit with hand control hydraulic valve• 4-way tilt capability
• Ability to easily be placed in a stationary position during surgery procedures by elevation of outside cylinders
• 46″ x 84″ lateral surface area (117cm x 213cm)
• 18″ x 84″ center bed (46cm x 213cm)
• Versatile multi-section table top surface
• Lowered height 22-1/2″ (57cm)
• Raised height 39″ (99cm)
• 6″ swivel casters
• Hot dip galvanized/painted coating on structural frame
• Rated for 2,500 lbs. (1,134KG)
Standard Accessories
• Flat extension (22” x 26”/56cm x 66cm)
• Set of four dorsal leg poles & tie loops
• Leverage bar
• Square tube offset bracket (for offset placement of flat extension for head)
Optional Accessories/Features
• V-head extension
• SS intestinal tray
• Free standing base (for SS intestinal tray)
• Lateral arthroscopic leg bracket
• Dorsal arthroscopic leg bracket (pair)
• 8” x 16” flat extension (20cm x 41cm)
• 12” x 20” flat extension (30cm x 51cm)
• SS IV Pole Round tube cross pipe
• D/L removable step
• D/L storage cart
• Foam positioning pads
Hydraulic System and Operation
The Table is user friendly and merely requires
access to power for operation. Once the table is
connected to power, an on/off switch turns on
the hydraulic system. The four outside cylinders
run individually or in combinations and can be
manipulated to achieve 4-way tilt. The inside
cylinders run in pairs. The Table is raised and
lowered by manipulation of the hand control
levers mounted on the table. The table can be
stopped at any position during raising or
lowering. The remaining two handles allow for
independent retraction of the casters on the head
and tail end of the table.
All optional accessories are easily connected to
the table by inserting them into any of the table
ports located around the perimeter of the table
top. The optional accessories allow for both
dorsal and lateral support.